Do I need to drill new holes for fog light cutouts or bumper sensors?

Check your OEM bumper hole locations and the cutout pattern on this cover before assembly. If your vehicle has factory fog lights or sensors, you may need to adapt or relocate existing holes to match the new bumper geometry. Dry-fit the cover first to confirm clearance.

Will this fit my current lower valance, or do I need to replace it?

The wide body design alters the lower rocker line and bumper proportions. Verify that your existing valance and side body lines are compatible with the extended geometry of this kit before ordering. If mixing OEM and aftermarket pieces, mock-fit components to confirm no gaps or overlap.

Should I paint before or after installation?

Most builders sand and prime this bumper off-vehicle, then paint and install. This gives you better control over edge detail and finish quality. You can also install unpainted and finish on the car if you have the masking setup. Either approach works—choose based on your shop workflow and paint access.