You look down the line of soldiers, knowing that their fate and the fate of your entire unit is dependent on your word. It is quite a heavy burden, far heavier than the magnificently polished steel Milanese Pauldrons on your shoulders.

“We must fight!” you shout for all to hear. “For our homes and for our families, we will fight until we can fight no more!” With a resounding cheer, your soldiers ready themselves for the charge. You withdraw your weapon, finding your resolve and setting your gaze upon the enemy.

DETAILS

Epic Armoury’s Polished Steel Milanese Pauldrons are a pair of simple low-fantasy shoulderguards. The pauldrons rest on top of the shoulders and cover the upper arms and a large portion of the upper back. Both are attractively curved to add structural strength to the steel while maintaining flexibility thanks to the overlapping plates. Asymmetrical in design, the left pauldron is fitted with a vertical plate designed to protect the head from glancing blows. These steel riveted pieces have been polished to a high-gloss finish to appeal to the knights in shining armour.

The Milanese Pauldrons are embellished with a top beveled plate to further deflect attacks, as well as a chain pin to attach an insignia. Secure them by tying the canvas ties to a breastplate or gambeson, and pulling the leather straps tight around the upper arms. They are fully usable with Epic Armoury’s Milanese Armour set, as well as other Epic Armoury metal work products, giving you the freedom to customize your character’s costume. Made of 1 mm thick mild steel and top-grain leather straps and fittings, this armour piece is built to withstand the abuse of a LARP or reenactment with regular leather and metal armour care.

HISTORY

• Historically designed with sculpted ridges and overlapping plates to provide reinforced protection and to deflect attacks on a chaotic battlefield
• Plate armour became more popular as firearm technology became more prevalent during the 13th century

• Made from 1mm/19 gauge thick mild steel
• Rolled edges with no sharp edges
• Straps and fittings made from top-grain leather
• Hand made, welded pieces for maximum durability
• Polished steel finish

Cleaning

If your armour does get wet, it is important that you dry it thoroughly as soon as possible.

After handling, wearing, or after six months of storage or display, all metal should be wiped with a clean cloth. Lightly oil the clean surface with a quality machine or mineral oil. Alternatively, you can apply a coating of wax to the entire surface of exposed metal. Allow the wax to dry for a couple of hours and then buff it lightly with a soft cloth.

Rust-Prevention and Removal

Store your armour is a dry place and check it every couple of months for signs of rust. If any is found, remove it by gently rubbing the affected spot with a mildly abrasive pad dipped in paste wax, oil, or water-displacing liquid.

Leather Straps and Fittings

Clean by removing dirt with a hard brush, then gently rub on leather soap with a clean, damp cloth until the leather appears clean. Remove soap with a separate damp cloth to wipe away any soap residue and then use a dry cloth to wipe away any remaining water from the leather.

You should always condition leather after cleaning, since the soap will have removed some of its natural oils. Treat the leather with mink oil, olive oil, or beeswax polish with a clean cloth, gently rubbing a small amount of oil or polish in circles into the leather. Allow the leather to soak in the oil before wiping the leather with a final clean cloth to remove any excess residue.